10 in 1 TRANSFER FOIL SET – MARBLES

10-piece color transfer foil set

Size: 4×100cm – 10pcs

Create unique-looking nails using patterned transfer films.
A special effect that your guests will love!
You can use the foil as a décor only by gluing it in parts, built in or even on the entire surface of the nail.

How to use?

1. Mattify the surface of the already finished artificial nail/gel polish with a buffer.
2. Apply the foil gel according to the pattern (this can be just decoration or even the entire nail surface), then bandage (according to your lamp for 5-30 seconds). After binding, DO NOT FIX IT UNDER ANY CIRCUMSTANCES! At this time, Foil Gel leaves a super immovable, sticky layer.
3. Cut a piece of transfer foil and place it on the knitted foil gel, press it thoroughly (e.g. with your finger, silicone Pen ,orange stick or even a threadless wipe  firmly stroking it everywhere), then remove/peel off the substrate layer with a quick firm movement.
4. After that, you can close the surface with a light gel.

EXTRA TIPS / HELP

❓ How long should foil jelly be knitted?
✅ The binding time varies in each lamp, so when using it for the first time, it is worth experimenting with the appropriate binding time for your lamp on 1-1 sample, which can be 5-30 seconds depending on the strength of your lamp.
(e.g. 10pm in EVO_X LED UV Lamp, 36sec in NL-30 UV  lamp)

❓ How do I know if the foil gel is set?
✅ If the foil no longer flows / slips on it (and when you take it back, the jelly does not stretch, but the foil sticks to it), then do not tie it anymore. If you overbind it, the foil gel will no longer stick properly.

❓ Wrinkle or rubbery surface: Apply very thinly, otherwise the surface
✅ may remain soft or wrinkled.

❓ Does not stick to the entire surface:
✅ The material is over-bonded, it requires less time in the lamp.

❓ The foil is too hard, I can’t brush it on the entire surface:
✅ You don’t have to press everywhere right away, try pressing / “scratching” it from one corner / edge, and as you go along, the foil will detach from the substrate. If necessary, you can cut the foil a little at the bends.

❓ The foil
✅ does not stick to it at all You may have put the wrong side on the sticky layer. Make sure that the glossy half of the foil is always on top, put the matte on the nail. Not sure which half to press on the transfer foil gel? If you scratch the surface a little, you will immediately see which side is its “color”.

Tip: Before use, wipe the back of the transfer foil with a Cleanser-soaked threadless paper towel to remove greasy and other dirt.

Tip: You can even use our transfer foil built into the nail, so you can achieve unique and special decorations with it!